Cultivation of Agaricus bisporus with water "four notes"

1. The bacteria water should be timely

The bacteriostatic water is sprayed when the hyphae appear on the surface of the bed. Method: Increase the ventilation, let the wind blow into the mushroom shed, so that the mycelium lodging, spray 1 kg of water per square meter of bed, sooner or later, so that the thickness of the soil layer 1/2 pervious. After spraying water, combined with strong ventilation, the surface of the bed about 0.5 cm thick is dehydrated and slightly whitish. The mycelium can grow laterally and connect within the thickness of the soil layer and reach a physiological maturity.

2 mushroom water to re-spray

Mushroom water was sprayed 3 days after the spraying of bacteria. According to the culture material and the soil moisture status, the mushroom water is sprayed in 4 times per square meter of bed surface, until the soil is wet but the water does not infiltrate. When spraying mushroom water, ventilation should be strengthened.

3 mushroom water should be sufficient

The amount of water used for mushrooming and the method of spraying are similar to those of mushroom water. At this point there have been mushroom buds, pay attention to try to make the water temperature and the greenhouse temperature similar, can not make the temperature difference is too large. In addition, there should be a small amount of water spray in the place where there are mushroom buds, and the total amount should be sufficient. However, care should be taken not to infiltrate the culture material.

4. Maintain water to spray

To maintain the water to spray, daily according to the temperature, ventilation and other conditions to control the number of water spray and water consumption, to maintain the humidity within the shed is about 90%, covering the surface of the basic moisture. If the soil at the vents and near the doorway is white, it is normal. With the continuous growth of fruiting bodies, the number of water sprays and the amount of water used should also continue to increase.

Long Range LiDAR Radar

Long distance LiDAR sensor series are particularly easy to communication thanks to their fixed connector, which can be plugged it up and off by yourself. Voltage is wider from 8v before to 36v. Low power consumption feature makes it beceome a very competitive, high performance-price ratio, long range Laser Distance Sensor.

Highlights:

> Measurement frequency: 400 Hz (Max 60m 3000Hz)
> Long range: 200m
> High temperatures: -10~+50℃
> UART output
> Connector design: easy to use

Parameters:

Chengdu JRT Main Ranging Modules: Industrial Laser Distance Sensors, Laser Rangefinder Sensor, Tof LiDAR Sensors.

Speed Laser Sensor,Long Range Lidar,Long Range 3D Lidar,Long Range Radar Sensor

Chengdu JRT Meter Technology Co., Ltd , https://www.rangingsensor.com