Exciter lubrication is as important as operation

The newly purchased vibration exciter is usually supplied with lubricating oil. It can be used as long as the test machine is normal. When using the exciter, regularly add lubricating oil to avoid bearing damage!

(1) Before the vibrating screen is driven, the operator should check the oil level on both sides of the vibrating screen at the same time. If the oil level is too high, the temperature of the exciter will rise or the operation will be difficult. If the oil level is too low, the bearing will be damaged prematurely.

(2) Check the tightening degree of all bolts, and re-tighten once after working for 8 hours at the beginning of zui.

(3 Check the tension of the V-belt to avoid slipping during starting or work, and to ensure the alignment of the V-belt.

(4) Ensure a small gap between all moving parts and the fixture.

(5 sieve machine should be started without load. After the vibrating screen runs smoothly, the feeding can be started. Before the vibrating screen stops, the feeding should be stopped first, and then the material on the sieve surface should be drained and then stopped.

(6 Feed chute should be as close as possible to the feed end, and as far as possible, the feed should be uniformly distributed along the full width of the sieve, the direction of which is consistent with the running direction of the material on the sieve surface, so that the sieve effect of Zui is better. Feeding point to sieve The large difference of the surface of the zui is not more than 500mm, ensuring a small impact of the material on the sieve surface.

(7 When the exciter rotates in the direction of the flow, increase the running speed of the material, which can increase the production capacity, but reduce the screening efficiency; when the exciter reverses the flow direction, reduce the material running speed and reduce the production capacity, which can be improved. Efficiency efficiency.