The operation steps of the body vacuum packaging machine

Instructions for using the body vacuum packaging machine :
1. Install the film: when the film holder is on the work surface, open the upper frame
2. Pull the film slightly over the right edge of the frame and press the upper frame to clamp the film.
3. Lift: Check if the "frame selection" switch k3 is in the "continuous" position, press the "up" switch k
4. Therefore, the membrane holder can be automatically stopped at the fixed point of the upper and lower proximity switch control. Before the lifting, the film roll should be loosened in advance to prevent the film from sticking to the film frame to stop rising.
5. Place the tray with the packaged items in the vacuum chamber of the working vacuum packaging machine. Use tools. Do not push them directly by hand to prevent personal injury in case of electrical failure.
6. Press the "Automatic Packaging" switch K6, the film is heated, the heat is lowered, and the pumping three programs are automatically completed from the time adjusted in advance.
7. When the membrane frame is automatically lowered to the low point of the limit switch control, the vacuum pump will pump the vacuum chamber. Therefore, it is found that the vacuum gauge motor has no action on the vacuum gauge, indicating that the vacuum pump motor is in reverse operation and should be stopped immediately. And to adjust any two phases in the input phase line and then start working again from the second program.
6. Open the upper frame, pull the packaged items to the right, place them on the auxiliary workbench, press the upper frame, cut the packaged items, and complete the packaging.
7. Start from the second item in the operating program and cycle at the beginning of the week.

Optical Fingerprint Scanner

Optical Fingerprint Scanner,Programmable Fingerprint Scanner,Biometric Optical Fingerprint Scanner,Wireless Small Optical Fingerprint Scanner

Shenzhen Bio Technology Co., Ltd , https://www.hfsecuritytech.com

Posted on