What is the method of checking when the laboratory rotary granulator is used?

Check the mixing paddle from the mirror on the lid. Press the paddle start button (green) to observe the steering of the paddle. - It should be counterclockwise. If the steering is not correct, the motor should be reversing, confirm the steering. start up. If there is abnormal noise during slow rotation, stop the inspection. Check that the steering of the granulating knife should be clockwise and the method of inspection is the same as above.

The laboratory rotary granulator adopts the working principle of tubular tube external heating. The material has short heating time, fast evaporation speed and large concentration ratio, which effectively maintains the original effect of the material. The energy saving effect is remarkable, and the steam saving amount is about 70% than that of the single effect evaporator. The material is evaporated and concentrated in a closed system, and the environment is clean and comfortable.

Commissioning airtight, hermetic cleaning and water cooling systems. Gas seals and hermetic seals are performed by a common set of tubing. When debugging, first turn the command switch to the stop position, observe whether the air chamber overflows or leaks in the air chamber, and if necessary, check the check valve. The second step is to turn the command switch to the intake position to check for gas.

Check the diaphragm switch for water in the water inlet position. If there is any abnormality, check the diaphragm valve. The water cooling is determined according to the temperature of the pot body and the process requirements. When the pot body is heated and needs to be cooled after continuous operation, the cooling water outlet valve can be opened to adjust the flow rate, and the flow rate is greatly cooled. At the same time, the required temperature setting is determined and automatically performed by temperature control.